What does Amana code E7 mean?
Amana furnace code E7 means the igniter or igniter-relay circuit reported a fault on the supported control family. Confirm the model number and diagnostic chart inside the furnace door before replacing parts.
What causes Amana code E7?
- A cracked or open hot-surface igniter
- Loose or damaged igniter wiring
- A failed igniter relay on the control board
Can I troubleshoot Amana code E7?
- Turn power off and look through the burner-viewing area for an obviously cracked igniter without touching it.
- Restore power once and observe whether the igniter glows; do not continue resetting the furnace.
How much does Amana code E7 cost to fix?
A furnace ignitor replacement typically costs between $150 and $500 nationally.
When should I call a technician?
Call a technician if the igniter does not glow or the fault returns.
Sources and model scope
Fault codes vary by model and control board. Confirm the diagnostic chart inside your furnace panel or the official manual before acting.
Scope used here: AR9S/GR9S and matching Daikin DR-series single-stage controls that display this E-code.
- Goodman Manufacturing: Service and Troubleshooting
RS6621301 · Goodman/Amana AR9S and GR9S, and Daikin DR-series single-stage furnace controls; use only for the E-code entries explicitly listed in the manual.
Compiled by Warmlo Editorial · Reviewed August 2026
This is general information, not professional advice. Gas, electrical, and combustion repairs can be dangerous — when in doubt, call a licensed technician.