What does Amana code E5 mean?
Amana furnace code E5 means the control-board fuse is open on the supported control family. Confirm the model number and diagnostic chart inside the furnace door before replacing parts.
What causes Amana code E5?
- Shorted thermostat wiring
- A shorted low-voltage accessory
- A damaged control-board circuit
Can I troubleshoot Amana code E5?
- Turn furnace power off and check for an obviously pinched thermostat wire without touching board terminals.
- Do not install a larger fuse or repeatedly replace a fuse that opens again.
How much does Amana code E5 cost to fix?
A control board replacement typically costs between $150 and $600 nationally.
When should I call a technician?
Call a technician to locate the low-voltage short before replacing the fuse again.
Sources and model scope
Fault codes vary by model and control board. Confirm the diagnostic chart inside your furnace panel or the official manual before acting.
Scope used here: AR9S/GR9S and matching Daikin DR-series single-stage controls that display this E-code.
- Goodman Manufacturing: Service and Troubleshooting
RS6621301 · Goodman/Amana AR9S and GR9S, and Daikin DR-series single-stage furnace controls; use only for the E-code entries explicitly listed in the manual.
Compiled by Warmlo Editorial · Reviewed August 2026
This is general information, not professional advice. Gas, electrical, and combustion repairs can be dangerous — when in doubt, call a licensed technician.