What does Rheem code 61 mean?
Rheem furnace code 61 means the indoor blower did not run when commanded on the supported control family. Confirm the model number and diagnostic chart inside the furnace door before replacing parts.
What causes Rheem code 61?
- Loss of power or communication to the blower motor
- A failed ECM motor module
- Damaged motor wiring or an incorrect control configuration
Can I troubleshoot Rheem code 61?
- Turn furnace power off and replace a visibly dirty filter.
- Restore power once and listen for the indoor blower; do not reach into the blower compartment.
How much does Rheem code 61 cost to fix?
A blower motor replacement typically costs between $350 and $1,400 nationally.
When should I call a technician?
Call a technician if the blower does not run or the communication fault returns.
Symptoms this code causes
Sources and model scope
Fault codes vary by model and control board. Confirm the diagnostic chart inside your furnace panel or the official manual before acting.
Scope used here: Rheem/Ruud RGFG-family controls using the documented two-digit diagnostic table.
- Rheem Manufacturing Company: RGFG Series Gas Furnace Installation Instructions and Diagnostic Codes
92-24161-104-06 · Rheem/Ruud RGFG-family furnace controls; confirm the unit model and its door chart before applying a code meaning.
Compiled by Warmlo Editorial · Reviewed August 2026
This is general information, not professional advice. Gas, electrical, and combustion repairs can be dangerous — when in doubt, call a licensed technician.