What does Daikin code E2 mean?
Daikin furnace code E2 means the pressure switch was open when the control expected it to be closed on the supported control family. Confirm the model number and diagnostic chart inside the furnace door before replacing parts.
What causes Daikin code E2?
- A blocked intake or exhaust vent
- A restricted condensate drain or pressure hose
- A weak inducer motor or pressure switch
Can I troubleshoot Daikin code E2?
- With the furnace off, check outdoor intake and exhaust openings for snow, ice, leaves, or nests.
- Replace a visibly dirty air filter, restore power once, and note whether the code returns.
How much does Daikin code E2 cost to fix?
A pressure switch replacement typically costs between $175 and $900 nationally.
When should I call a technician?
Call a technician if the vent is clear and the pressure-switch code returns; combustion-air testing requires instruments.
Sources and model scope
Fault codes vary by model and control board. Confirm the diagnostic chart inside your furnace panel or the official manual before acting.
Scope used here: AR9S/GR9S and matching Daikin DR-series single-stage controls that display this E-code.
- Goodman Manufacturing: Service and Troubleshooting
RS6621301 · Goodman/Amana AR9S and GR9S, and Daikin DR-series single-stage furnace controls; use only for the E-code entries explicitly listed in the manual.
Compiled by Warmlo Editorial · Reviewed August 2026
This is general information, not professional advice. Gas, electrical, and combustion repairs can be dangerous — when in doubt, call a licensed technician.